Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side.
How to remove sliding door off track.
Keep lowering the panel until it is completely out of the upper track and free.
Moving the door when the back side is sliding on the ground is a little difficult.
Then sharply angle the bottom of the door outward and lift the door from the track.
To remove a bottom supported sliding door lift and then tilt the bottom out of the track.
Then hold the spring loaded top pivot down while you swing the top of the door toward the frame and under the door track.
Once the door is approximately under the hole in the track release the pivot.
Begin by inserting the bottom pivot into the bracket which can be screwed to the floor to the door jamb or both.
4 removing the sliding door before removing the door slide it to the point in the track where you see an indent.
Pull the door up from the bottom track until the wheels are out.
You will be able to tell the wheels are sufficiently.
Bring the door to within a few inches of the strike side jamb.
Slide the door over.
Lift a bottom supported door such as an sliding glass patio door straight up to clear the bottom track.
Slip a flat screwdriver underneath the wheels and push them upwards.
Taking the door out of the track 1.
Getting off track remove the outside closet door by first sliding the door to the center of the track.
Once you remove all the screws lift the door up and make sure that it is completely removed from the bottom track of the door frame.
Loosen every single screw to ensure that you don t miss one and crack your.
Then angle the door towards you and pull gently detaching the door from its top track.
Then tilt it slightly with help and remove it from the upper track of the door frame as well.
Work the door slowly into the opening in this manner.
In order to remove the sliding one effectively lift it upwards into the upper track and ask a helper to push the bottom gently and carefully toward you.
Even if you have brackets on the bottom of your door they re probably just connected to your wheels.
Sliding patio doors have two separate units namely the sliding door panel and the stationary panel.
Do this with a helper.